Five Tools That Everyone In The Fiat 500 Replacement Key Cost Industry Should Be Making Use Of
Fiat 500 Replacement Key Fob
It's possible to replace the battery if the 500 remote key fob isn't working. If you replace the battery, but it doesn't work it could be the issue elsewhere.
United Locksmith specializes in the creation of new keys for classic automobiles. We have the tools and components needed for this service.
Dead Coin Battery
The most common reason your Fiat 500 key fob will not unlock or lock the doors is due to a dead battery. The key fob is equipped with a coin cell battery that is prone to draining quickly when it isn't being frequented enough. If your remote started to show signs of weakness such as a loss in range and then completely stopped working the battery could be dead.
The battery inside the key fob is held in place with metal clips for retaining. If the clips are not tight, they can create problems with the contact, which can stop your remote from receiving power. By using a small flathead screwdriver, pry the clip that holds the retaining pin open to take out the battery and replace it with a new one. Make sure you use a replacement with the same kind of voltage, size and specifications as the original battery.
Water exposure can cause the key fob to become corroded or damaged. Even a short bath in soapy, warm water could cause damage to the chip. Make sure your key fob is dry.
Water Damage
If your key fob isn't functioning properly, it could be caused by water damage. Key fobs are fitted with rubber seals that prevent them from being damaged by a light rain or a splash of water. However, it is essential to keep your car keys safe from the pool, ocean, and the washing machine!
The key fob contains an electronic chip inside that sends a signal to your car's immobilizer system. This is the reason why your 500 can lock or start, but in the event that the chip becomes wet, it's unable to longer function.
If you're looking to determine whether your key fob still working, you can clean the internal electronics using isopropyl or electronic cleaner. However, it is probably better to purchase a new one from a dealer rather than trying to repair an item that was submerged in salt water.
While a replacement fob can cost you a little bit of money, it's far less expensive than paying for your Fiat 500 to be towed to a dealership and fixed! In addition, you can do it yourself in several easy steps. Just make sure you have the right battery type before you attempt to open your key fob. There are step-by-step directions for any car keyfob online.
Faulty Chip
The chip in the key fob communicates with the vehicle's immobiliser to ensure that the vehicle is capable of starting when the correct key is used. If the chip is damaged or destroyed the car will not start no matter what you do.
A damaged chip could occur due to several reasons, but the most common cause is water damage or a dead battery. It is recommended to leave the job to a professional locksmith who can repair the chip in a short time and at a an affordable price.
If your key fob will not work after exposure to clean tap or rain water then remove the battery. Clean the electronic component using a towel. If fiat 500 key fob replacement will not function, there is the possibility that it's damaged components and requires to be replaced.
Some people will go to their dealer when in need of an entirely new Fiat key fob, however this is a expensive alternative. United Locksmith is the best place to go if you are looking to have your Fiat keyfob fixed at a reasonable cost. We have the tools and experience needed to fix your Fiat fob quickly and professionally. manner.
Faulty Receiver Module
Fiat key fobs transmit a signal to the vehicle which will unlock and close doors (and start the car for vehicles with an automatic transmission) up to 50 feet. There are several reasons why the fob may stop working. This includes a dead coin battery water damage buttons, worn out buttons as well as a receiver module problem and signal interference, or a malfunctioning electronic chip.
If the fob was in a pocket that has been subject to extreme trauma, like being dropped on hard floors or getting washed in a wash machine, it may not be capable of communicating with the car's Body Control Module (BCM). This is because the BCM is a secure system that can only accept signals from a genuine key and not accept any other.
You'll have to replace the fob if this occurs. A professional locksmith will handle the entire process of replacing keys including programming a new key to your 500. They can even provide the fob cloned to work exactly like the original (and costs a fraction of the cost).
